CardLock 2

CardLock 2

The CardLock 2 is a access validator with a stand-alone configuration and operation. To configure it, you do not need any access control software, just use its infrared controller.

This device is able to validate previously registered identifiers and only these identifiers can activate the internal relay and open the door. To do this, simply use the registration option and approach the card or other RFID device.

With the CardLock 2 infrared controller you can:

  • - Register a new card or a user;
  • - Delete a card or a user;
  • - Configure the door opening time and the operating mode;
  • - Configure the door open timeout;
  • - Delete all cards or users;
  • - Change the access password;
  • - Configure the open door sensor operation;

This product is available in these versions:

  • - With or without graphic display;
  • - With a RFID 125 kHz reader or a 13.56 MHz (Mifare) reader.

The CardLock 2 is designed to be installed inside a wall switch box (standard EU 70 mm), leaving only a surface area of approximately 8 mm outside the wall.

The fact that all electronics are embedded inside the wall, in addition to increasing the security level of the access system, also gives the product an attractive and elegant design, so that it can be applied even in cases where they are required high architectural standards.

Features:

  • - Internal IR (infrared) receiver;
  • - Includes IR controller;
  • - Internal beetle;
  • - Low power consumption;
  • - Mechanical relay for latches and electromagnetic locks activation;
  • - 128 x 64 OLED display (optional);
  • - Micro USB port;
  • - High strength and durability;
  • - Power from 9 to 32 volts DC;
  • - Photo coupled input;
  • - Open door sensor input;
  • - Input for other options;


  • - Green and red LEDs;
  • - Non-volatile memory for data storage;
  • - Validation of up to 800 preconfigured identifiers;
  • - Firmware upgrade via USB;
  • - Built-in/embed mounting;
  • - Fast-connect connectors for power and relay connections;
  • - Dimensions (outside the wall): 88 mm x 85 mm x 8 mm;
  • - Dimensions (inside the wall): 53 mm x 53 mm x 54 mm;
  • - Internal 125 kHz or 13.56 MHz (Mifare) RFID reader;